Droop Load Adjuster


A Spring Preload adjuster intended to allow adjustment of spring pressure at full droop without removing the shock or adjusting the lockout nut on the slider. Each unit consists of a 3D Printed Base (grey) and Nut (blue) that can adjust from .800"-1.200" for .400" of droop load adjustment. This increases (or decreases) droop load 80 lbs on a 200lb spring. Adjustments are made on the car with the rear hanging using 2 spanner wrenches (not included), and the position is secured with a small zip tie (5 included). 


50 Items